Viewing Logs From Fabric Manager Web Server; Viewing Logs From Device Manager; Default Settings - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Chapter 63 Configuring System Message Logging
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Viewing Logs from Fabric Manager Web Server

To view system messages remotely using Fabric Manager Web Server, follow these steps:
Point your browser at the Fabric Manager Web Server. See the
Step 1
section on page
Click the Events tab followed by the Details to view the system messages. The columns in the events
Step 2
table are sortable. In addition, you can use the Filter button to limit the scope of messages within the
table.

Viewing Logs from Device Manager

You can view system messages from Device Manager if Device Manager is running from the same
workstation as the Fabric Manager Server. Choose Logs > Events > current to view the system
messages on Device Manager. The columns in the events table are sortable. In addition, you can use the
Find button to locate text within the table.
You can view switch-resident logs even if you have not set up your local syslog server or your local PC
is not in the switch's syslog server list. Due to memory constraints, these logs will wrap when they reach
a certain size. The switch syslog has two logs: an NVRAM log that holds a limited number of critical
and greater messages and a nonpersistent log that contains notice or greater severity messages. Hardware
messages are part of these logs.
When using the show logging command, output is displayed only when the configured logging levels
Note
for the switch are different from the default levels.

Default Settings

Table 63-4
Table 63-4
Parameters
System message logging to the console
System message logging to Telnet sessions
Logging file size
Log file name
Logging server
Syslog server IP address
Number of servers
Server facility
OL-16184-01, Cisco MDS SAN-OS Release 3.x
7-7.
lists the default settings for system message logging.
Default System Message Log Settings
"Launching Fabric Manager Web Server"
Default
Enabled for messages at the critical severity level.
Disabled.
4194304.
Message (change to a name with up to 200 characters).
Disabled.
Not configured.
Three servers.
Local 7.
Cisco MDS 9000 Family CLI Configuration Guide
Default Settings
63-11