HP Cisco MDS 9216 - Fabric Switch Configuration Manual page 582

About Zoning
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Each VSAN has a full database and an active database.
•
Active zone sets cannot be changed, without activating a full zone database.
•
Active zone sets are preserved across switch reboots.
•
Changes to the full database must be explicitly saved.
•
Zone reactivation (a zone set is active and you activate another zone set) does not disrupt existing
•
traffic.
If required, you can additionally configure the following zone features:
Propagate full zone sets to all switches on a per VSAN basis.
•
Change the default policy for unzoned members.
•
Interoperate with other vendors by configuring a VSAN in the interop mode. You can also configure
•
one VSAN in the interop mode and another VSAN in the basic mode in the same switch without
disrupting each other
Bring E ports out of isolation.
•
Cisco MDS 9000 Family CLI Configuration Guide
30-4
Chapter 30 Configuring and Managing Zones
OL-16184-01, Cisco MDS SAN-OS Release 3.x