HP Cisco MDS 9216 - Fabric Switch Configuration Manual page 1062

Default Settings
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 50-2
Parameters
SACK
max-bandwidth
min-available-bandwidth
round-trip-time
Buffer size
Control TCP and data connection
TCP congestion window monitoring
Burst size
Jitter
TCP connection mode
Fibre Channel targets to iSCSI
Advertising iSCSI target
iSCSI hosts mapping to virtual Fibre
Channel hosts
Dynamic iSCSI initiators
Identifying initiators
Advertising static virtual targets
iSCSI login authentication
revert-primary-port
Header and data digest
iSNS registration interval
iSNS registration interval retries
Fabric distribution
Table
Table 50-3
Parameters
Fabric distribution
Load balancing metric
Cisco MDS 9000 Family CLI Configuration Guide
50-76
Default iSCSI Parameters (continued)
50-3lists the default settings for iSLB parameters.
Default iSLB Parameters
Default
Enabled.
1Gbps
70 Mbps.
1 msec.
4096 KB.
No packets are transmitted.
Enabled.
50 KB.
500 microseconds.
Active mode is enabled.
Not imported.
Advertised on all Gigabit Ethernet interfaces,
subinterfaces, PortChannel interfaces, and PortChannel
subinterfaces.
Dynamic mapping.
Members of the VSAN 1.
iSCSI node names.
No initiators are allowed to access a virtual target (unless
explicitly configured).
CHAP or none authentication mechanism.
Disabled.
Enabled automatically when iSCSI initiators send
requests. This feature cannot be configured and is not
available in store-and-forward mode.
60 sec (not configurable).
3.
Disabled.
Default
Disabled.
1000.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Chapter 50 Configuring iSCSI