HP Cisco MDS 9216 - Fabric Switch Configuration Manual page 1198

Contact Information
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 64-1
In Device Manager, click Admin > Events > Call Home. See
Step 2
Figure 64-2
Click the General tab, then assign contact information and enable the Call Home feature. Call Home is
Step 3
not enabled by default. You must enter an e-mail address that identifies the source of Call Home
notifications.
Click the Destination(s) tab to configure the destination e-mail addresses for Call Home notifications.
Step 4
You can identify one or more e-mail addresses that will receive Call Home notifications.
Note
Click the Email Setup tab to identify the SMTP server. Identify a message server to which your switch
Step 5
has access. This message server will forward the Call Home notifications to the destinations.
Step 6 In Fabric Manager, click the Apply Changes icon. In Device Manager, click Apply.
Cisco MDS 9000 Family CLI Configuration Guide
64-4
Call Home in Fabric Manager
Call Home in Device Manager
Switches can forward events (SNMP traps/informs) up to 10 destinations.
Chapter 64 Configuring Call Home
Figure 64-2.
OL-16184-01, Cisco MDS SAN-OS Release 3.x