Cfs Example Using Device Manager; Default Settings - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Chapter 13 Using the CFS Infrastructure
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

CFS Example Using Device Manager

This procedure is an example of what you see when you use Device Manager to configure a feature that
uses CFS. For specific procedures for features that use CFS, refer to that feature's documentation.
To configure a feature that uses CFS using Device Manager, follow these steps:
Step 1 Open the dialog box for any CFS-capable feature. Device Manager checks to see whether CFS is
enabled. It also checks to see if there is a lock on the feature by checking for at least one entry in the
Owner table. If CFS is enabled and there is a lock, Device Manager sets the status to "pending" for that
feature. You see a dialog box displaying the lock information.
Click Continue or Cancel when prompted. If you continue, Device Manager remembers the CFS status.
Step 2
Choose Admin > CFS (Cisco Fabric Services) to view the user name of the CFS lock holder.
Step 3
Click the locked feature and click Details.
Step 4
Click the Owners tab and look in the UserName column.
Step 5
Note
Step 6 If CFS is enabled and there is no lock, Device Manager sets the status to running for that feature.
You then see a dialog box for the feature. As soon as you perform a creation, deletion, or modification,
Device Manager changes the status to "pending" and displays the updated information from the pending
database.
Step 7 View the CFS table for a feature. Device Manager only changes the status to "running" when commit,
clear, or abort is selected and applied. Device Manager will not change the status to "pending" if enable
is selected, because the "pending" status does not apply until the first actual change is made.
The Last Command and Result fields are blank if the last command is noOp.
Note When using CFS with features like DPVM and device alias, you must select commit at the end of each
configuration. If the session is locked, you must exit the feature by selecting abort.

Default Settings

Table 13-1
Table 13-1
Parameters
CFS distribution on the switch
Database changes
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Device Manager does not monitor the status of the feature across the fabric until you click
Refresh. If a user on another CFS-enabled switch attempts to configure the same feature, they
do not see the "pending" status. However, their configuration changes are rejected by your
switch.
lists the default settings for CFS configurations.
Default CFS Parameters
Default
Enabled.
Implicitly enabled with the first configuration change.
Cisco MDS 9000 Family CLI Configuration Guide
CFS Example Using Device Manager
13-19