Creating A Santap Dvt - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Chapter 57 Configuring SANTap
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Expand Switches > End Devices and then select SSM Features from the Physical Attributes pane.
Step 1
You see the FCWA tab in the Information pane.
Click the SANTap CVT tab.
Step 2
You see the SANTap configuration in the Information pane.
Step 3 Select the SANTap CVT you want to delete.
Step 4 Click Delete Row.
You see the Fabric Manager Confirmation dialog box.
Step 5 Click Yes to proceed with the deletion or click No to discard the changes.

Creating a SANTap DVT

To create a SANTap DVT using Fabric Manager, follow these steps:
Expand Switches > End Devices and then select SSM Features from the Physical Attributes pane.
Step 1
You see the FCWA tab in the Information pane.
Step 2 Click the SANTap DVT tab.
You see the SANTap configuration in the Information pane (see
Figure 57-4
Step 3 Click Create Row.
You see the create SANTap DVT dialog box shown in
OL-16184-01, Cisco MDS SAN-OS Release 3.x
SANTap DVT Tab
Figure 57-4).
Figure 57-5.
Cisco MDS 9000 Family CLI Configuration Guide
Configuring SANTap
57-5