HP Cisco MDS 9216 - Fabric Switch Configuration Manual page 321

Chapter 15 Software Images
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 15-4
Click the row under the System, Kickstart, ASM-SFN, or SSI columns to enter image URIs.You must
Step 5
specify at least one image for each switch to proceed.
Step 6 Click Next.
You see the Check Flash Free Space dialog box (see
standby, if applicable) bootflash space on each switch, and shows the status (whether there is enough
space for the new images). If any switch has insufficient space, you cannot proceed. Deselect the switch
without enough bootflash by going back to the first screen and unchecking the check box for that switch.
Figure 15-5
Step 7 Click Next.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Specify Software Image(s) by Model Dialog Box
Check Flash Free Space Dialog Box
Using the Software Install Wizard
Figure 15-5). This dialog box shows the active (and
Cisco MDS 9000 Family CLI Configuration Guide
15-9