Configuring Fcip Tape Acceleration - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Using the FCIP Wizard
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 48-1
Host
Host 1
Host 2
Table 48-2
Table 48-2
Host
Host 1
Host 2
Another example setup is when a tape drive is shared by multiple hosts through a single tape port. For
instance, Host 1 has access to Drive1 and Drive2, and Host 2 has access to Drive 2, Drive 3, and Drive
4. A correct LUN mapping configuration for such a setup is shown in
Table 48-3
Host
Host 1
Host 2

Configuring FCIP Tape Acceleration

To enable FCIP tape acceleration using Fabric Manager, follow these steps:
Step 1 From Fabric Manager, choose ISLs > FCIP from the Physical Attributes pane.
You see the FCIP profiles and links in the Information pane.
From Device Manager, choose IP > FCIP.
You see the FCIP dialog box.
Click the Tunnels tab. You see the FICP link information.
Step 2
Click the Create Row icon in Fabric Manager or the Create button in Device Manager.
Step 3
You see the FCIP Tunnels dialog box.
Set the profile ID in the ProfileID field and the tunnel ID in the TunnelID fields.
Step 4
Cisco MDS 9000 Family CLI Configuration Guide
48-36
Correct LUN Mapping Example with Single Host Access
LUN Mapping
LUN 1
LUN 2
LUN 3
LUN 4
describes incorrect tape library LUN mapping.
Incorrect LUN Mapping Example with Single Hosts Access
LUN Mapping
LUN 1
LUN 2
LUN 1
LUN 2
Correct LUN Mapping Example with Multiple Host Access
LUN Mapping
LUN 1
LUN 2
LUN 2
LUN 3
LUN 4
Chapter 48
Drive
Drive 1
Drive 2
Drive 3
Drive 4
Drive
Drive 1
Drive 2
Drive 3
Drive 4
Table 48-3.
Drive
Drive 1
Drive 2
Drive 2
Drive 3
Drive 4
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Configuring FCIP