HP Cisco MDS 9216 - Fabric Switch Configuration Manual page 367

Chapter 19 Managing Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 19-7
LED
Status Green
Speed On
Link
The LEDs on the supervisor module indicate the status of the supervisor module, power supplies, and
the fan module.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
LEDs for the Cisco MDS 9000 Family Fibre Channel Switching Modules
Status Description
All diagnostics pass. The module is operational (normal initialization sequence).
Orange One of the following applies:
The module is booting or running diagnostics (normal initialization sequence).
The inlet air temperature of the system has exceeded the maximum system
operating temperature limit (a minor environmental warning). To ensure
maximum product life, you should immediately correct the environmental
temperature and restore the system to normal operation.
Red One of the following applies:
The diagnostic test failed. The module is not operational because a fault occurred
during the initialization sequence.
he inlet air temperature of the system has exceeded the safe operating
T
temperature limits of the card (a major environmental warning). The card has
been shut down to prevent permanent damage.
2-Gbps mode.
Off 1-Gbps mode.
Solid green Link is up.
Steady Link is up (beacon used to identify port).
flashing
green
Intermittent Link is up (traffic on port).
flashing
green
Solid Link is disabled by software.
yellow
Flashing A fault condition exists.
yellow
Off No link.
Table 19-8 provides more information about these LEDs.
Cisco MDS 9000 Family CLI Configuration Guide
Identifying Module LEDs
19-11