Configuring Dhchap Aaa Authentication; Enabling Fc-Sp On Isls; Default Settings - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Default Settings

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Click the Apply Changes icon to save the updated information.
Step 4

Configuring DHCHAP AAA Authentication

You can individually set authentication options. If authentication is not configured, local authentication
is used by default.
To configure the AAA authentication refer to the Cisco MDS 9000 Family CLI Configuration Guide,

Enabling FC-SP on ISLs

There is an ISL pop-up menu in Fabric Manager called Enable FC-SP that enables FC-SP on switches
at either end of the ISL. You are prompted for an FC-SP generic password, then asked to set FC-SP
interface mode to ON for affected ports. Right-click an ISL and click Enable FC-SP to access this
feature.
Default Settings
Table 45-2
Table 45-2
Parameters
DHCHAP feature
DHCHAP hash algorithm
DHCHAP authentication mode
DHCHAP group default priority
exchange order
DHCHAP timeout value
Cisco MDS 9000 Family CLI Configuration Guide
45-10
lists the default settings for all fabric security features in any switch.
Default Fabric Security Settings
Chapter 45
Default
Disabled.
A priority list of MD5 followed by SHA-1 for DHCHAP
authentication.
Auto-passive.
0, 4, 1, 2, and 3 respectively.
30 seconds.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Configuring FC-SP and DHCHAP