Default Settings - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Default Settings

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 48-5
Table 48-5
Bandwidth
>25Mbps
10-25Mbps
10Mbps
The Cisco MDS 9216i and 9222i Switches also supports the IP compression feature. The integrated
Note
supervisor module has the same hardware components that are available in the MPS-14/2 module.
Caution The compression modes in Cisco SAN-OS Release 2.0(1b) and later are incompatible with the
compression modes in Cisco SAN-OS Release 1.3(1) and earlier.
While upgrading from Cisco SAN-OS Release 1.x to Cisco SAN-OS Release 2.0(1b) or later, we
Tip
recommend that you disable compression before the upgrade procedure, and then enable the required
mode after the upgrade procedure.
If both ends of the FCIP link are running Cisco SAN-OS Release 2.0(1b) or later and you enable
compression at one end of the FCIP tunnel, be sure to enable it at the other end of the link.
Default Settings
Table 48-4
Table 48-6
Parameters
TCP default port for FCIP
minimum-retransmit-time
Keepalive timeout
Maximum retransmissions
PMTU discovery
pmtu-enable reset-timeout
SACK
max-bandwidth
min-available-bandwidth
round-trip-time
Buffer size
Control TCP and data connection
Cisco MDS 9000 Family CLI Configuration Guide
48-38
lists the performance settings for different cards.
Performance Settings
IPS Card
mode1
mode2
mode3
lists the default settings for FCIP parameters.
Default FCIP Parameters
MPS 14/2 Card 18+4/9222i
mode1 mode2/mode3
mode2 mode2/mode3
mode3 mode2/mode3
Default
3225
200 msec
60 sec
4 retransmissions
Enabled
3600 sec
Enabled
1Gbps
500 Mbps
1 msec
0 KB
No packets are transmitted
Chapter 48 Configuring FCIP
OL-16184-01, Cisco MDS SAN-OS Release 3.x