Chapter 50
Configuring iSCSI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 50-13
Step 4
Set the iSCSI target node name in the iSCSI Name field, in IQN format.
Step 5
Set the Port WWN field for the Fibre Channel target port you are mapping.
Click the Select from List radio button and set the iSCSI initiator node names or IP addresses that you
Step 6
want this virtual iSCSI target to access, or click the All radio button to let the iSCSI target access all
iSCSI initiators. Also see the
Step 7
Click the Select from List radio button and check each interface you want to advertise the iSCSI targets
on or click the All radio button to advertise all interfaces.
Step 8
Click Apply to save this change.
Tip
An iSCSI target cannot contain more than one Fibre Channel target port. If you have already mapped the
whole Fibre Channel target port, you cannot use the LUN mapping option.
Note
See the
to statically mapped targets.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Create iSCSI Targets Dialog Box
"iSCSI Access Control" section on page
"iSCSI-Based Access Control" section on page 50-26
50-24.
for more information on controlling access
Cisco MDS 9000 Family CLI Configuration Guide
Configuring iSCSI
50-11