HP Cisco MDS 9216 - Fabric Switch Configuration Manual page 1116

SCSI Flow Services
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Expand End Devices and then select SSM Features in the Physical Attributes pane.
Step 1
You see the Intelligent Storage Services configuration in the Information pane.
Click the SSM tab.
Step 2
You see the set of configured services in the Information pane shown in
Figure 55-2
Click Create Row to enable a new service on an SSM.
Step 3
You see the Create SSM dialog box shown in
Figure 55-3
Select the switch and SSM card you want to configure.
Step 4
Optionally, uncheck the Use All Ports on Module check box if you want to provision a subset of the
Step 5
ports on the card to use this service.
Select the port range you want to provision for using this service (starting port and ending port).
Step 6
Note
Select the feature you want to enable on these ports from the drop-down list of services.
Step 7
Set the PartnerImageURI field if you are enabling a third-party application that requires an image loaded
Step 8
onto the SSM.
Click Create to create this row and enable this service.
Step 9
To configure a Fibre Channel using Fabric Manager, follow these steps:
Expand End Devices and then select SSM Features in the Physical Attributes pane.
Step 1
You see the Intelligent Storage Services configuration, showing the FCWA tab in the Information pane
shown in
Cisco MDS 9000 Family CLI Configuration Guide
55-4
SSM Tab
Create SSM Dialog Box
The port range must be a multiple of four (for example fc4/1 through fc4-12).
Figure 55-4.
Chapter 55 Configuring SCSI Flow Services and Statistics
Figure 55-3.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Figure 55-2.