c. Type the IP address or DNS host name of the trap recipient (SNMP
management workstation) in the associated Trap Recipient field. Use 64 or
fewer alphanumeric characters. Hewlett-Packard recommends using the IP
address.
Figure 3–10: Configure SNMP dialog box
d. Type a decimal user datagram protocol (UDP) port number in the associated
UDP Port Number field. (This number is commonly 162.)
2. To enable transmission of trap messages to configured SNMP management
workstations, click Enable Authorization Traps. A check mark displays in the
box when transmission is enabled.
3. Click Activate to save the information and close the dialog box.
4. If you are finished configuring the director, back up the configuration data. For
more information, refer to
Configuring Open Systems Management Server
For complete procedures on configuring this optional feature, refer to
the Open Systems Management
Configuring FICON Management Server
For complete procedures on configuring this optional feature, refer to
the FICON Management
director product manager user guide
"Backup and Restore
Server" on
page
Server" on
page
6–2.
Configuring the Director
Configuration" on
6–5.
page
5–6.
"Configuring
"Configuring
3–23