Vsan Membership For Iscsi - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Configuring iSCSI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 50-22
Step 4 Check the Proxy Mode Enable check box.
Step 5 Click the Apply Changes icon in Fabric Manager or click Apply in Device Manager to save these
changes.
When an interface is in proxy initiator mode, you can only configure Fibre Channel access control
Note
(zoning) based on the iSCSI interface's proxy N port attributes—the WWN pairs or the FC ID. You
cannot configure zoning using iSCSI attributes such as IP address or IQN of the iSCSI initiator. To
enforce initiator-based access control, use iSCSI based access control (see the
section on page

VSAN Membership for iSCSI

Similar to Fibre Channel devices, iSCSI devices have two mechanisms by which VSAN membership can
be defined.
•
•
VSAN Membership for iSCSI Hosts
Individual iSCSI hosts can be configured to be in a specific VSAN (similar to the DPVM feature for
Fibre Channel, see
interface VSAN membership.
To assign VSAN membership for iSCSI hosts using Fabric Manager, follow these steps:
Choose End Devices > iSCSI in the Physical Attributes pane.
Step 1
You see the iSCSI tables in the Information pane (see
Select the Initiators tab.
Step 2
You see the iSCSI initiators configured.
Fill in the VSAN Membership field to assign a VSAN to the iSCSI hosts.
Step 3
Cisco MDS 9000 Family CLI Configuration Guide
50-22
iSCSI Tab in Device Manager
50-24).
iSCSI host—VSAN membership to iSCSI host. (This method takes precedent over the iSCSI
interface.)
iSCSI interface—VSAN membership to iSCSI interface. (All iSCSI hosts connecting to this iSCSI
interface inherit the interface VSAN membership if the host is not configured in any VSAN by the
iSCSI host method.)
Chapter 28, "Creating Dynamic
Chapter 50
VSANs"). The specified VSAN overrides the iSCSI
Figure 50-5).
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Configuring iSCSI
"iSCSI Access Control"