Deleting A Santap Dvt - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Configuring SANTap
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 57-5
Step 4 Select the switch on which the SANTap DVT will be configured.
Step 5 Select the VSAN ID in which you want to create the SANTap DVT.
Step 6 Select the port WWN of the real target for which this corresponding DVT is being created. The DVT
has the same port WWN as the target.
Step 7 Select the target VSAN ID for the VSAN of the real target for which this DVT is being created.
Step 8 Select the interface. This is the port on the module where the DVT will be created.
Step 9 Assign a name to this SANTap DVT.
Check the LunSizeHandling option if you want to use the real target LUN size for the virtual LUN or
Step 10
the maximum LUN size supported (2TB).
Step 11 Select the IOTimeout value for the DVT. The default value is 10 seconds.
Click Create to create this SANTap DVT.
Step 12

Deleting a SANTap DVT

To delete a SANTap DVT using Fabric Manager, follow these steps:
Step 1 Expand Switches > End Devices and then select SSM Features from the Physical Attributes pane.
You see the FCWA tab in the Information pane.
Step 2 Click the SANTap DVT tab.
You see the SANTap configuration in the Information pane.
Step 3 Select the SANTap DVT you want to delete.
Click Delete Row.
Step 4
You see the Fabric Manager Confirmation dialog box.
Cisco MDS 9000 Family CLI Configuration Guide
57-6
Create SANTap DVT Dialog Box
Chapter 57 Configuring SANTap
OL-16184-01, Cisco MDS SAN-OS Release 3.x