Configuring Fcip Write Acceleration - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Chapter 48 Configuring FCIP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Caution FCIP write acceleration with FCIP ports as members of PortChannels in Cisco MDS SAN-OS Release
2.0(1b) and later are incompatible with the FCIP write acceleration in earlier releases.

Configuring FCIP Write Acceleration

You can enable FCIP write acceleration when you create the FCIP link using the FCIP Wizard.
You can enable FCIP write acceleration when you create the FCIP link using the FCIP Wizard.
To enable write acceleration on an existing FCIP link, follow these steps:
Step 1 Choose ISLs > FCIP from the Physical Attributes pane on Fabric Manager.
You see the FCIP profiles and links in the Information pane.
On Device manager, choose IP > FCIP.
You see the FCIP dialog box.
Click the Tunnels (Advanced) tab.
Step 2
You see the FICP link information (see
Figure 48-23
Check or uncheck the Write Accelerator check box.
Step 3
Choose the appropriate compression ratio from the IP Compression drop-down list.
Step 4
Click the Apply Changes icon to save these changes.
Step 5
Choose ISLs > FCIP from the Physical Attributes pane on Fabric Manager.
Step 1
You see the FCIP profiles and links in the Information pane.
On Device manager, choose IP > FCIP.
You see the FCIP dialog box.
Click the Tunnels (Advanced) tab.
Step 2
You see the FICP link information (see
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Figure
FCIP Tunnels (Advanced) Tab
Figure
48-23).
48-23).
Cisco MDS 9000 Family CLI Configuration Guide
Using the FCIP Wizard
48-31