Manually Enabling Ficon On A Vsan; Deleting Ficon Vsans - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Configuring FICON
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 36-9
Enter the VSAN membership information.
Step 12
Click the VSAN you want to become a FICON VSAN and select Add from the FICON drop-down menu.
Step 13
Click Apply to save these changes.
Step 14

Manually Enabling FICON on a VSAN

This section describes the procedure to manually enable FICON on a VSAN. If you have already enabled
Note
FICON on therequired VSAN using the automated setup (recommended), skip to the
Saving the Running Configuration" section on page
To manually enable FICON on a VSAN using Fabric Manager, follow these steps:
Choose VSAN > FICON.
Step 1
You see the FICON VSAN configuration information in the Information pane.
Step 2 Select the switch in the VSAN on which you want to enable FICON.
Step 3 Click enable from the Command drop-down menu.
Step 4 Click the Apply Changes icon to save these changes.

Deleting FICON VSANs

To delete a FICON VSAN using Fabric Manager, follow these steps:
Select All VSANS.
Step 1
You see the VSAN table in the Information pane (see
Cisco MDS 9000 Family CLI Configuration Guide
36-18
VSAN Dialog Box in Device Manager
Chapter 36
36-23.
Figure 36-10).
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Configuring FICON
"Automatically