Chapter 48
Configuring FCIP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 48-19
Connecting switch (peer) = 10.1.1.1
IP address of Gigabit Ethernet
interface 3/1 = 10.100.1.25
Verifying Interfaces and Extended Link Protocol
To verify the FCIP interfaces and Extended Link Protocol (ELP) on Device Manager, follow these steps:
Make sure you are connected to a switch that contains an IPS module.
Step 1
Select FCIP from the Interface menu.
Step 2
Click the Interfaces tab if it is not already selected. You see the FCIP Interfaces dialog box.
Step 3
Click the ELP tab if it is not already selected. You see the FCIP ELP dialog box.
Step 4
Checking Trunk Status
To check the trunk status for the FCIP interface on Device Manager, follow these steps:
Step 1
Make sure you are connected to a switch that contains an IPS module.
Select FCIP from the IP menu.
Step 2
Click the Trunk Config tab if it is not already selected. You see the FCIP Trunk Config dialog box. This
Step 3
shows the status of the interface.
Step 4
Click the Trunk Failures tab if it is not already selected. You see the FCIP Trunk Failures dialog box.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Assigning Profiles to Each Gigabit Ethernet Interface
Endpoint
Interface FCIP = 51
Profile = 10
Switch 1
FCIP link
Switch 1
IP router
Endpoint
Interface FCIP = 52
Profile = 20
Connecting switch (peer) = 10.100.1.25
Virtual (E) ISL
IP router
IP
network
IP address of Gigabit Ethernet
interface 3/1 = 10.1.1.1
Cisco MDS 9000 Family CLI Configuration Guide
Using the FCIP Wizard
Switch 2
Switch 2
48-17