Enabling Or Disabling Fspf; Fspf Interface Configuration; About Fspf Link Cost - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

FSPF Interface Configuration

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Click Apply Changes to save these changes, or click Undo Changes to discard any unsaved changes.
Step 3

Enabling or Disabling FSPF

To enable or disable FSPF using Fabric Manager, follow these steps:
Step 1 Expand a Fabric, expand a VSAN and select FSPF for a VSAN that you want to configure for FSPF.
You see the FSPF configuration in the Information pane as shown in
Step 2 Set the Status Admin drop-down menu to up to enable FSPF or to down to disable FSPF.
Step 3 Click Apply Changes to save these changes, or click Undo Changes to discard any unsaved changes.
FSPF Interface Configuration
Several FSPF commands are available on a per interface basis. These configuration procedures apply to
an interface in a specific VSAN.
This section includes the following topics:
•
•
•
•
•
•
•
•
•
•
•
•

About FSPF Link Cost

FSPF tracks the state of links on all switches in the fabric, associates a cost with each link in its database,
and then chooses the path with a minimal cost. The cost associated with an interface can be
administratively changed to implement the FSPF route selection. The integer value to specify cost can
range from 1 to 65,535. The default cost for 1 Gbps is 1000 and for 2 Gbps is 500.
Cisco MDS 9000 Family CLI Configuration Guide
32-6
About FSPF Link Cost, page 32-6
Configuring FSPF Link Cost, page 32-7
About Hello Time Intervals, page 32-7
Configuring Hello Time Intervals, page 32-8
About Dead Time Intervals, page 32-8
Configuring Dead Time Intervals, page 32-8
About Retransmitting Intervals, page 32-8
Configuring Retransmitting Intervals, page 32-9
About Disabling FSPF for Specific Interfaces, page 32-9
Disabling FSPF for Specific Interfaces, page 32-9
Displaying the FSPF Database, page 32-10
Viewing FSPF Statistics, page 32-11
Chapter 32 Configuring Fibre Channel Routing Services and Protocols
Figure
OL-16184-01, Cisco MDS SAN-OS Release 3.x
32-4.