Releasing Shared Resources In A Port Group - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Chapter 22 Configuring Generation 2 Switches and Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Select in or out from the Status Service column.
Step 5
Click the Apply Changes icon.
Step 6
.

Releasing Shared Resources in a Port Group

When you want to reconfigure the interfaces in a port group on a Generation 2 module, you can return
the port group to the default configuration to avoid problems with allocating shared resources.
The interface cannot be a member of a PortChannel.
Note
Caution Releasing shared resources disrupts traffic on the port. Traffic on other ports in the port group is not
affected.
To release the shared resources for a port group using Fabric Manager, follow these steps:
Select a switch from the Fabric pane, or select a group of switches (SAN, fabric, VSAN) from the
Step 1
Logical Domains pane.
Expand Switches > Interfaces and then select FC Physical from the Physical Attributes pane.
Step 2
You see the FC Physical > General tab in the Information pane.
Scroll down until you see the row containing the switch and port you want to configure.
Step 3
Scroll right (if necessary) until you see the Status Service column (see
Step 4
Figure 22-12
Step 5 Select the out status from the Status Service column.
Step 6 Click the Apply Changes icon.
Step 7 Select the in status from the Status Service column.
Step 8 Click the Apply Changes icon.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Status Service Column for FC Physical
Configuring Generation 2 Module Interface Shared Resources
Figure
Cisco MDS 9000 Family CLI Configuration Guide
22-12).
22-29