HP Cisco MDS 9216 - Fabric Switch Configuration Manual page 1049

Chapter 50 Configuring iSCSI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 50-43
Host 1
iSCSI
iSCSI
Host 2
To configure scenario 2 (see
Step 1 Configure null authentication for all iSCSI hosts.
In Fabric Manager, choose End Devices > iSCSI in the Physical Attributes pane.
a.
Select none from the AuthMethod drop-down menu in the Information pane.
b.
Click the Apply Changes icon.
c.
Configure iSCSI to dynamically import all Fibre Channel targets into the iSCSI SAN using
Step 2
auto-generated iSCSI target names.
In Device Manager, click IP > iSCSI.
a.
Click the Targets tab.
b.
Check the Dynamically Import FC Targets check box.
c.
Click Apply.
d.
Configure the Gigabit Ethernet interface in slot 7 port 1 with an IPv4 address and enable the interface.
Step 3
a. In Fabric Manager, choose Switches > Interfaces > Gigabit Ethernet in the Physical Attributes
pane.
Select the IP Address tab in the Information pane and click Create Row.
b.
c. Set the IP address and subnet mask for the Gigabit Ethernet interface in slot 7 port 1.
d. Click Create.
e. Click the General tab and select up from the Admin drop-down menu for the Gigabit Ethernet
interface in slot 7 port 1.
f. Click the Apply Changes icon.
Step 4 Configure the iSCSI interface in slot 7 port 1 to identify all dynamic iSCSI initiators by their IP address
and enable the interface.
a. In Fabric Manager, choose Switches > Interfaces > FC Logical in the Physical Attributes pane.
b. Select the iSCSI tab in the Information pane.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
iSCSI Scenario 2
VSAN 1
Switch 1
VSAN 2
Figure 50-43), follow these steps:
iSCSI Authentication Setup Guidelines and Scenarios
Interface fc 2/1
21:00:00:20:37:6f:fd:97
Interface fc 2/5
iSCSI
21:00:00:20:37:6f:fe:54
Interface fc 2/9
21:00:00:20:37:a6:a6:5d
Cisco MDS 9000 Family CLI Configuration Guide
50-63