Configuring Nasb - HP Cisco MDS 9216 - Fabric Switch Configuration Manual

Default Settings
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 58-5
Step 4 Select the Switch and Module on which you want to configure NASB.
Note
Step 5 Select the VSAN ID you want to configure for NASB.
Note
Step 6 Choose the Control option to enable NASB on the SSM in one slot and on one VSAN for a single target
LUN that is a Storage Array Controller (Peripheral Device Type = 0x0C).
Step 7 Choose the Multiple option to enable NASB on the SSM in one slot and on one VSAN for up to 10 target
LUNs that are Direct Access Devices (Peripheral Device Type = 0x00).
Note
Note
Step 8 Click Create to create this NASB.
You cannot simultaneously configure the intelligent services SANTap and NASB on a single SSM.
Note
Default Settings
Table 58-1
Cisco MDS 9000 Family CLI Configuration Guide
58-6
NASB Configuration Dialog Box
NASB must be enabled and provisioned as a service on this SSM module. See the
Intelligent Storage Services" section on page
You must configure this VSAN to permit default zoning.
Use the multiple option for multi-streaming (multiple backup sessions) on a single virtual target
for VERITAS NetBackup.
For information on specific settings, consult with your NASB partner.
lists the default settings for NASB parameters.
Chapter 58
58-2.
OL-16184-01, Cisco MDS SAN-OS Release 3.x

Configuring NASB

"Enabling