Redialing Features; Using Record-A-Call; I Last Number Redial (F05) - Avaya PARTNER ACS Installation And Use Manual

Programming
To program a Record-a-Call button:
f00
1. Press
2. Press a programmable button with LEDs.
3. Press f24
4. Program another extension, or exit programming mode.

Using Record-a-Call

To activate the feature, press the programmed feature button when active on an intercom or CO
call. The green LED at the feature button is turned on steady to indicate that feature activation has
been initiated. When PMVS connects, the LEDs become an alternating red and green flash.
Any one of the following deactivates Record-a-Call:
You press the Record-a-Call button again.
I
You hang up the call.
I
PMVS drops the call because the recording time limit was exceeded.
I
Call recording terminates because silence was detected on the line for 15 seconds.
I

Redialing Features

Use the following features to redial telephone numbers:
Last Number Redial
I
Save Number Redial
I
Last Number Redial (F05)
Use this feature to redial the last outside number dialed (maximum 28 digits). Last Number
Redial is useful for immediately redialing a busy number.
Considerations
Last Number Redial redials all digits dialed on the last outside call except account codes.
I
You can program a Last Number Redial button on a system telephone to redial a number with
I
one touch.
You can use Save Number Redial (F04) to temporarily save the last number dialed. The
I
difference between Last Number Redial and Save Number Redial is that Save Number
Redial allows you to make other outside calls before redialing the saved number.
.
.
Programming & Using Telephone Features

Redialing Features

8-51