Using Centralized Telephone Programming; Remote Programming - Avaya PARTNER ACS Installation And Use Manual

Remote Programming

Available for use with PARTNER ACS Release 3.0 or later, PARTNER ACS Remote
Administration software provides the capability to perform remote administration and programming
(except for the Hong Kong 3.0 version) from a remote or local PC. For more information about the
PARTNER ACS Remote Administration software, see your Avaya representative or authorized
dealer.

Using Centralized Telephone Programming

Use Centralized Telephone Programming from extension 10 or 11 to program features or store
telephone numbers for individual extensions. All features that can be programmed at an extension
can also be programmed by using Centralized Telephone Programming. Most features also can be
programmed on a system telephone at the user's extension, except for the following:
Automatic Line Selection, Line Ringing, and Call Screening (F25) always must be
I
programmed by using Centralized Telephone Programming.
If an extension has a single-line telephone, you must program all features for the extension by
I

using Centralized Telephone Programming.

If an extension has a non-display system telephone, you must use Centralized Telephone
I
Programming to program Extension Name Display for the extension.
During Centralized Telephone Programming, the display telephone at extension 10 or 11 takes on
the characteristics of the telephone being programmed, including any System Programming
settings and lines assigned to the telephone. See
more information about System Programming and the use of overlays.
To program a telephone from extension 10 or 11, follow these steps:
1. Place the Programming Overlay over the dialpad of the system display telephone at extension
10 or 11.
f00
2. Press
PROGRAM EXTENSION 10
(If you are programming from extension 11, "11" displays instead of "10.")
s
3. Press
10 Enter Extension Name
This display is for the Extension Name Display feature. Skip to Step 4.
s
4. Press
SYSTEM PROGRAM
c
5. Press
CENTRAL TELEPHONE PROG
Extension:
. A display similar to the following appears:
. A display similar to the following appears:
again. The display reads:
. A display similar to the following appears:
Initial System Programming
"Using System Programming" on page 3-2
Using Centralized Telephone Programming
for
3-7