Key Extensions - Avaya PARTNER ACS Installation And Use Manual

®
PARTNER Advanced Communications System Installation, Programming, and Use
In Hybrid and Key mode, do not use this feature to add lines to the system after initial setup,
I
because it changes the following features for individual lines back to factory settings:
– Line Assignment
– Line Access Restriction
– Automatic Line Selection
– Line Ringing
To change line assignments without affecting other settings, use Line Assignment (#301).
I
If your system has a 1600 DSL module (Release 4.0 and later systems), the module is
I
automatically assigned 16 lines. If you have less than 16 lines actually equipped for service,
you may remove the unequipped line appearances from the extension telephones by using
Line Assignment (#301).
Programming
To assign lines to the system at initial system setup:
f00ss#104
1. Press
2. Enter two digits for the number of outside lines in the system to assign to all extensions or the
main pool. For example, entering
6 or lines 1 through 6 are assigned to the main pool.
3. Select another procedure, or exit programming mode.

Key Extensions

In Key mode, all extensions are Key extensions; in Hybrid mode, extension 10 and any extensions
set to Key by using Line Access Mode (#313) are key extensions.
After you program the Number of Lines, use the following features as needed:
Dial Mode (#201) to identify any rotary lines (the default for all lines is "touch-tone").
I
Line Assignment (#301) to assign lines to specific extensions (if the line was not assigned
I
using the Number of Lines procedure), to remove lines from some extensions, or to change
the button used to pick up a line at a specific extension.
Line Access Restriction (#302) to prevent an extension from receiving and/or making
I
outside calls on specific lines.
Line Ringing (Centralized Telephone Programming) to specify when a line starts ringing at
I
each extension that has the line.
Automatic Line Selection (Centralized Telephone Programming) to specify the order in which
I
the system selects an available line (intercom or outside) when a user at the extension lifts the
handset or presses
Assigning Lines
3-12
06 means that all extensions are assigned lines 1 through
S
to make a call without first selecting a specific line button.
at extension 10 or 11.