Loudspeaker Paging System - Avaya PARTNER ACS Installation And Use Manual

4. To program another extension, press
on the display. Repeat Step 3.
5. Select another procedure, or exit programming mode.

Loudspeaker Paging System

Loudspeaker paging systems allow you to broadcast a message over a large area. The system
supports all Avaya paging systems, including the entire PagePac line. The system also supports
most paging systems from other manufacturers when the paging systems are connected using a
paging interface device. Follow these steps to connect a paging system to the processor module
(see Figure 9-11):
If you connect a loudspeaker paging system from another manufacturer, a paging
interface may be required.
1. Insert the modular plug into the PAGE jack on the processor module (located near the middle
of the processor, just above the line jacks).
When you connect a paging system to the PAGE jack, use a two-pair, twisted-pair
cable between the paging system and the processor module.
2. Route the cord through the processor module's wire manager.
3. Connect the other end of the cord to the paging system.
Figure 9-11. Connecting the Paging System
n or p until the extension number appears
Using Auxiliary Equipment

Loudspeaker Paging System

9-25