Problems With Manual Backup; At Idle Extensions 10 And 11; Display Shows "Insert Valid Card" In System Programming Mode; Display Shows "Card Is Write Protected" In System Programming Mode - Avaya PARTNER ACS Installation And Use Manual

Display Shows "Backup Failed:SystemBusy"

at Idle Extensions 10 and 11

Possible Cause: Changes were being made to system programming or central telephone
programming while a backup was in progress.
What to do: The backup is rescheduled for the next day at 2:00 a.m. Enter Backup
Programming–Automatic (#123) and select Option 3 to clear the alarm display (see
Backup-Failure Alarm" on page

Problems with Manual Backup

Display Shows "Insert Valid Card" in
System Programming Mode
Possible Cause: The system did not detect a valid Backup/Restore PC Card when you tried to do a
manual backup by using Backup Programming–Manual (#124).
What to do: Power down the system, insert a valid Backup/Restore PC Card in PC Card Slot 2 of
the PARTNER ACS processor module, and reapply power to the system. Restart the procedure.
Display Shows "Card is Write Protected" in
System Programming Mode
Possible Cause: You tried to do a manual backup by using Backup Programming–Manual
(#124), but the Backup/Restore PC Card in the PC Card slot is write-protected.
What to do: Using the end of a paper clip or another pointed object, gently push the write-protect
tab upward to the nonprotected position (see
again. (You do not need to remove the card from the processor to slide the write-protect tab up.)
Display Shows "System Busy" in
System Programming Mode
Possible Cause: An automatic or manual backup was in progress at the time you requested a
manual backup.
What to do: Exit the procedure and retry the manual backup after a few minutes.
11-4).
Figure 11-1 on page
Troubleshooting
"Clearing a
11-22), and try the procedure

Problems with Manual Backup

11-23