Call Waiting (#316); Considerations; Programming - Avaya PARTNER ACS Installation And Use Manual

®
PARTNER Advanced Communications System Installation, Programming, and Use

Considerations

The Caller ID Type you set applies to the entire system.
I
A change to the Caller ID Type setting takes effect when the next Caller ID call comes into the
I
system.

Programming

To change the Caller ID Type setting:
f00ss#122
1. Press
The system shows the current setting.
D
2. Press
the factory setting:
1 = USA (the factory setting) ✔
I
2 = Singapore
I
3. Select another procedure, or exit programming mode.

Call Waiting (#316)

Use this feature to activate Call Waiting. When you are on a call and a second intercom,
transferred, or outside call comes in, you hear two beeps to indicate you have a second call waiting
to be answered. Press the switchhook (or Recall or Flash button, if available) to put the current call
on hold and retrieve the second call. To return to the first call, press the switchhook again.
Considerations
This feature is distinct from the local telephone company's Call Waiting feature. If you use this
I
system feature, do not use your local telephone company's Call Waiting feature.
The Call Waiting tone (two beeps) is not repeated.
I
Use Call Waiting only for single-line telephone extensions. Do not assign Call Waiting to
I
extensions that have fax machines, credit card scanners, modems, or auto attendants
because the call-waiting tone interrupts the data connection.
You cannot transfer either party connected by Call Waiting, conference in additional parties,
I
or use feature codes while both calls are active.
Transfer-return, group call distribution, hunt group, and wake-up calls are not considered
I
incoming calls for this feature.
For instructions on using Call Waiting, see
I
Call Waiting does not apply to parked calls.
I

Call Waiting (#316)

4-14
d
or until the appropriate value appears, or press
at extension 10 or 11.
"Answering Calls" on page
r
to return to
6-19.