Voice Gateway Configuration - Avaya PARTNER ACS Installation And Use Manual

Voice Gateway Configuration

Follow these steps to configure the voice gateway path:
1. Select "P. VoicePath Configure" from the Main Menu.
2. Select "V. Set Voice Gateway" from the Voice Configuration menu.
3. Select one of the following voice gateways according to your service provider from the Voice
Gateway Selection menu:
1. CopperCom
I
2. MGCP 0.1/NCS 1.0 (PathStar)
I
3. Jetstream
I
If you selected Jetstream or CopperCom, you are done with the voice gateway
configuration. If you selected MGCP 0.1/NCS 1.0 (PathStar), continue with the
procedure.
4. Select "M. Manage MGCP/NCS Embedded Client" from the Main Menu.
5. Select "C. Configure MGCP/NCS parameters" from the MGCP/NCS Management Menu.
6. Type the default IP address for the Notified Entity. Get this address from your service provider;
this is the IP address for the gateway (the PathStar).
7. Type the IP address to use for MGCP signaling (data signaling). This is the IP address of the
voice PVC/DLCI on the SDSL port; get it from your service provider.
8. Enter the TOS byte value for Signalling packets at the prompt; get this from your service
provider.
9. Type the IP address to use for RTP transport (voice). Usually this is the same address as the
voice PVC/DLCI; get it from your service provider.
10. Enter the TOS byte value for RTP (Voice) packets at the prompt; get this from your service
provider.
11. Press Esc to return to the Main Menu.
Router Configuration for Voice (PathStar Only)
When you are connecting to a PathStar gateway, you must configure the voice PVC. Follow these
steps to configure the voice PVC for the 1600 DSL module when you are connecting to a PathStar
gateway:
1. Select "2. Configure IP Router" from the Main Menu.
2. Select "C. Configure Port IP Address" from the Router Configuration Menu.
3. Select "1. SDSL" from the Available Interfaces list.
Installation
The 1600 DSL Module
2-23