Avaya PARTNER ACS Installation And Use Manual page 109

Considerations
For pooled extensions, use Pool Access Restriction (#315) to assign restrictions to all the
I
lines assigned to a specific pool. (Pool Access Restriction overrides Line Access
Restriction.) For individual lines on pooled extensions, use Line Access Restriction.
To prevent an extension from using a line, restrict the line even if it is not assigned to the
I
extension, so the line cannot be accessed by Direct Line Pickup.
If an extension's access to a line is set to No Access or In Only, the extension cannot place
I
calls on that line, neither by pressing the line button, nor by using Direct Line Pickup–Idle
Line.
If an extension's access to a line is set to No Access or Out Only, the extension cannot receive
I
calls on that line that are ringing at other extensions, neither by pressing the line button, nor by
using Direct Line Pickup–Active Line.
Caller ID information does not appear for ringing calls on lines programmed for Out Only or
I
No Access.
If a line is assigned to a telephone but is restricted to No Access, the line button LEDs show
I
calling activity; but the line cannot be used to place or receive calls.
Programming
To restrict an extension from making calls on a specific line:
f00ss#302
1. Press
2. At the Extension : prompt, enter the extension number to be programmed.
3. At the Line : prompt, enter the line number to be restricted at this extension.
The current restriction appears.
4. To change the line restriction for this extension, press
appears.
1 = No Restriction (calls permitted on that line; this is the factory setting) ✔
I
2 = Out Only (can only make outside calls, not receive them, on that line)
I
3 = In Only (can only receive calls, not make them, on that line)
I
4 = No Access (cannot receive or make calls, but can join calls, receive transferred calls,
I
or pick up calls on hold on that line)
5. Do one of the following:
To restrict another line at this extension, press
I
shows on the display. Repeat Step 4.
To restrict another extension, press
I
6. Select another procedure, or exit programming mode.
at extension 10 or 11.
D
n
or
N P
+
Dialing Restrictions and Permissions
Programming System Options
until the appropriate value
p
until the line number
and begin at Step 2.
4-23