Sntp Server Configuration; Figure 44: Sntp Server Configuration; Table 34: Sntp Server Configuration Fields - D-Link DWS-4026 User Manual

D-Link Unified Access System
Field
Broadcast Poll Interval
Unicast Poll Timeout
Unicast Poll Retry
• If you change any of the settings on the page, click Submit to apply the changes to system.
SNTP S C
ERVER ONFIGURATION
Use the SNTP Server Configuration page to view and modify information for adding and modifying Simple Network Time
Protocol SNTP servers.
To display the SNTP Server Configuration page, click LAN > Administration > SNTP > SNTP Server Configuration in the
navigation tree.
Field
Server
Address / Hostname
Address Type
Port
Page 98 Configuring SNTP Settings
Table 33: SNTP Global Configuration Fields (Cont.)
Description
Specifies the number of seconds between broadcast poll requests expressed as a
power of two when configured in broadcast mode. Broadcasts received prior to the
expiry of this interval are discarded. Allowed range is (6 to 10). Default value is 6.
Specifies the number of seconds to wait for an SNTP response when configured in
unicast mode. Allowed range is (1 to 30). Default value is 5.
Specifies the number of times to retry a request to an SNTP server after the first time-
out before attempting to use the next configured server when configured in unicast
mode. Allowed range is (0 to 10). Default value is 1.

Figure 44: SNTP Server Configuration

Table 34: SNTP Server Configuration Fields

Description
Select the IP address of a user-defined SNTP server to view or modify information
about an SNTP server, or select Create to configure a new SNTP server. You can
define up to three SNTP servers.
Enter the IP address or the hostname of the SNTP server.
Select IPv4 if you entered an IPv4 address or DNS if you entered a hostname.
Enter a port number from 1 to 65535. The default is 123.
Software User Manual
Document 34CSFP6XXUWS-SWUM100-D7
12/10/09