Traceroute; Figure 81: Autoinstall; Table 66: Autoinstall Fields - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
After obtaining IP addresses for both the switch and the TFTP server, the AutoInstall feature attempts to download a host-
specific configuration file using the boot file name specified by the DHCP server. If the switch fails to obtain the file, it will
retry indefinitely.
To display this page, click Tool > AutoInstall in the navigation menu.
Field Description
AutoInstall Mode • Select Start to initiate sending a request to a DHCP server to obtain an IP address of a server and
the configuration file name. If it obtains the server address, AutoInstall proceeds to search for and
download a configuration file from the server. If successful, it applies the configuration file to the
switch. After starting the AutoInstall process, you can monitor the status of the process by the
messages in the AutoInstall State and Retry Count fields.
• Click Stop to end the process.
AutoSave Mode Enable or Disable saving the network configuration to non-volatile memory. When enabled, the
configuration is saved after downloading from the TFTP server without operator intervention. When
disabled, the operator must explicitly save the configuration, if needed.
Retry Count The number of times the switch has attempted to contact the TFTP server during the current
AutoInstall session.
AutoInstall State The status of the current or most recently completed AutoInstall session.
Click Submit to update the switch with the values on the window. Click Refresh to update the information on the window.
T R
RACE OUTE
You can use the TraceRoute utility to discover the paths that a packet takes to a remote destination.
To display this page, click LAN > Administration > TraceRoute in the navigation tree.
Document 34CSFP6XXUWS-SWUM100-D7

Figure 81: AutoInstall

Table 66: AutoInstall Fields

D-Link Unified Access System
Using System Utilities Page 149