Figure 336: Rf Scan; Table 312: Access Point Rf Scan Status - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
To view additional information about a detected AP, click the MAC address of the AP.
Table 312 describes the fields on the Rogue/RF Scan page.
Field
MAC Address
SSID
Physical Mode
Channel
Status
Transmit Rate
Age
Use the buttons at the bottom of the page to perform the actions
Document 34CSFP6XXUWS-SWUM100-D7

Figure 336: RF Scan

Table 312: Access Point RF Scan Status

Description
The Ethernet MAC address of the detected AP. This could be a physical radio interface or VAP
MAC. For D-Link APs this is always a VAP MAC address.
Service Set ID of the network, which is broadcast in the detected beacon frame.
Indicates the 802.11 mode being used on the AP.
Transmit channel of the AP.
Indicates the managed status of the AP, whether this is a valid AP known to the switch or a
Rogue on the network. The valid values are:
• Managed: The neighbor AP is managed by the wireless system.
• Standalone: The AP is managed in standalone mode and configured as a valid AP entry
(local or RADIUS).
• Rogue: The AP is classified as a threat by one of the threat detection algorithms.
• Unknown: The AP is detected in the network but is not classified as a threat by the threat
detection algorithms.
Indicates the rate at which the AP is currently transmitting data.
Time since this AP was last detected in an RF scan.
D-Link Unified Access System
Table 313 describes.
Monitoring and Managing Intrusion Detection Page 489