Configuring A Virtual Access Point; Table 343: Vap Configuration Example Settings - D-Link DWS-4026 User Manual

D-Link Unified Access System
C
ONFIGURING A
The following example shows how to configure the default virtual access point (VAP) profile on the switch. After the switch
authenticates an AP it discovers on the network, it assigns the default profile to the AP. In order for the switch and AP to
discover each other, the WLAN Switch feature must be enabled on the UWS, and the Managed Mode must be enabled on
the AP.
The default profile in this example has three enabled VAPs with the following settings:
Network (SSID) VLAN
Visitor 10
Corporate 20
Voice 30
The Voice network uses the default RADIUS server configured on the system to authenticate clients and has the L2
Distributed Tunneling Mode enabled.
When L2 Distributed tunneling is enabled, note the following network considerations:
• If APs are located in different subnets, the client VLANs must also be separated by a router so that
the VLANs do not form a single bridge segment.
• If the IP addresses of the APs are on the same subnet, all VLANs used by the wireless clients must
also be located in the same bridge segment.
The Voice network also uses a DiffServ policy to expedite the voice traffic. The policy must already be configured in order
to associate it with the Voice network. You configure the policy by using the pages available from the LAN > QoS >
Differentiated Services folder. For information about configuring DiffServ policies, see
for VoIP" on page 554.
1 Access the WLAN > Administration > Basic Setup page, and then click the SSID tab.
By default, Network 1 is enabled and uses "Guest Network" as the SSID.
2 Configure the first VAP.
a. Click Edit for Network 1 to access the Wireless Network Configuration page for that network.
b. Delete the existing SSID and enter Visitor in the SSID field.
c. In the VLAN field, enter 10.
d. In the Redirect field, select the HTTP option.
e. In the Redirect URL field, enter www.dlink.com.tw
f. In the Bandwidth Limit Down field, enter 3000000 to limit the download speed to 3 Mbps for the VAP.
g. In the Bandwidth Limit Up field, enter 100000 to limit the upload speed to 1 Mbps for the VAP.
h. Click Submit to apply the settings to the switch.
Page 550

Configuring a Virtual Access Point

V A
IRTUAL CCESS

Table 343: VAP Configuration Example Settings

Security
None
WPA Personal
WPA Enterprise
P
OINT
Redirect
http://www.dlink.com.tw
None
None
Document 34CSFP6XXUWS-SWUM100-D7
Software User Manual
Client QoS
http://www.dlink.com.tw
Bandwidth Restrictions
None
DiffServ Policy Up
"Configuring Differentiated Services
12/10/09