Trap Flags; Figure 65: Trap Receiver Configuration; Table 55: Trap Receiver Configuration Fields - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
Field
Community
SNMP Community Name
SNMP Version
Protocol
IP Address
Status
If you make any changes to the page, click Submit to apply the changes to the system. If you want the switch to retain the
new values across a power cycle, you must perform a save.
T F
RAP LAGS
Use the Trap Flags page to enable or disable traps at a component level that the switch can send to an SNMP manager.
When the condition identified by an active trap is encountered by the switch, a trap message is sent to any enabled SNMP
Trap Receivers, and a message is written to the trap log. If the component level trap flag is disabled, then no trap is sent to
the SNMP Manager even if the individual traps in that component are enabled.
To access the Trap Flags page, click LAN > Administration > SNMP Manager > Trap Flags page.
Document 34CSFP6XXUWS-SWUM100-D7

Figure 65: Trap Receiver Configuration

Table 55: Trap Receiver Configuration Fields

Description
When this field is set to Create, you can configure new SNMP trap receiver information
in the rest of the fields. If you have already configured an SNMP trap receiver, you can
select it from the drop-down menu to change the settings or delete it.
Enter the community string for the SNMP trap packet to be sent to the trap manager.
This may be up to 16 characters and is case sensitive.
Select the trap version to be used by the receiver from the pull down menu:
• SNMP v1. Uses SNMP v1 to send traps to the receiver.
• SNMP v2. Uses SNMP v2 to send traps to the receiver.
Select the type of protocol used for the SNMP Trap Receiver Configuration:
• IPv4. Choose IPv4 to enter the address in IPv4 format.
• IPv6. Choose IPv6 to enter the address in IPv6 format.
Enter the IP address in dotted-decimal format to receive SNMP traps from this device.
Select the receiver's status from the pulldown menu:
• Enable: Send traps to the receiver
• Disable: Do not send traps to the receiver.
D-Link Unified Access System
Defining SNMP Parameters Page 127