Configuring An Existing Loopback; Removing A Loopback; Removing A Secondary Address; Figure 227: Loopbacks Configuration-Ipv4 Entry - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
3 Click Submit.
The Loopback ID field goes away, and additional loopback fields display, as
4 In the Protocol field, select IPv4
5 Enter desired values in the remaining fields.
6 Click Submit.
The new loopback is saved, and the web page reappears showing secondary address configuration fields. For an
example of the fields on this page, see
7 Optionally, complete the Secondary Address, Secondary IP Address, and Secondary Subnet Mask fields.
8 Click the Add Secondary button. The secondary address is saved, and the web page reappears showing the primary
and secondary loopback addresses.

Configuring an Existing Loopback

1 Open the Loopback Configuration page.
2 Specify the loopback to configure in the Loopback menu.
3 Change field values as desired in the remaining fields.
4 Click Apply Changes.
The new configuration is saved, and the device is updated.

Removing a Loopback

1 Open the Loopback Configuration page.
2 Specify the loopback to remove in the Loopback menu.
3 Click Delete Loopback.
The loopback is deleted, and the device is updated.

Removing a Secondary Address

1 Open the Loopback Configuration page.
2 Specify the loopback to be affected.
3 Specify the secondary address to be removed.
4 Click Delete Selected Secondary.
The secondary address is deleted, and the device is updated.
Document 34CSFP6XXUWS-SWUM100-D7
Figure 227: Loopbacks Configuration—IPv4 Entry
Figure 226.
D-Link Unified Access System
Figure 227 shows.
Loopback Interfaces Page 323