D-Link Unified Access System
C
ONFIGURING AND
The Industry Standard Discovery Protocol (ISDP) is a proprietary Layer 2 network protocol which inter-operates with Cisco
devices running the Cisco Discovery Protocol (CDP). ISDP is used to share information between neighboring devices. D-
Link software participates in the CDP protocol and is able to both discover and be discovered by other CDP supporting
devices.
The following pages are accessible from this ISDP folder:
•
"Global Configuration"
•
"Cache Table"
•
"Interface Configuration"
•
"Statistics"
G
C
LOBAL
ONFIGURATION
From the ISDP Global Configuration page, you can configure the ISDP settings for the switch, such as the administrative
mode. To display the ISDP Global Configuration page, click LAN > Administration > ISDP > Global Configuration in
the navigation tree.
The following table describes the fields available on the ISDP Global Configuration page.
Field
ISDP Mode
ISDP V2 Mode
Message Interval
Holdtime Interval
Page 170
Configuring and Viewing ISDP Information
V
ISDP I
IEWING
Figure 97: ISDP Global Configuration
Table 82: ISDP Global Configuration
Description
Use this field to enable or disable the Industry Standard Discovery Protocol on the
switch.
Use this field to enable or disable the Industry Standard Discovery Protocol v2 on the
switch.
Specifies the ISDP transmit interval. The range is (5–254). Default value is 30
seconds.
The receiving device holds ISDP message during this time period. The range is (10–
255). Default value is 180 seconds.
NFORMATION
Document 34CSFP6XXUWS-SWUM100-D7
Software User Manual
12/10/09
®