D-Link Unified Access System
5 Select the type of authentication to use.
If you select Simple or Encrypt as the authentication, the screen refreshes, and additional fields display. Enter the
required information into the new fields.
6 Click Submit to apply the changes to the system and return to the RIP Interface Configuration page.
7 To cancel the authentication configuration and return to the RIP Interface Configuration page, click Cancel.
RIP I
S
NTERFACE
UMMARY
Use the RIP Interface Summary page to display RIP configuration status on an interface.
To display the page, click LAN > Monitoring > L3 Status > RIP > Interface Summary in the navigation tree.
Field
Slot/Port
IP Address
Send Version
Page 296
Configuring RIP
Figure 202: RIP Interface Authentication Configuration
Figure 203: RIP Interface Summary
Table 184: RIP Interface Summary Fields
Description
The interface, such as the routing-enabled VLAN on which RIP is enabled.
The IP Address of the router interface.
Specifies the RIP version to which RIP control packets sent from the interface conform.
The default is RIP-2. Possible values are:
• RIP-1: RIP version 1 packets are sent using broadcast.
• RIP-1c: RIP version 1 compatibility mode. RIP version 2 formatted packets are
transmitted using broadcast.
• RIP-2: RIP version 2 packets are sent using multicast.
• None: RIP control packets are not transmitted.
Software User Manual
Document 34CSFP6XXUWS-SWUM100-D7
12/10/09