Vlan Status; Vlan Configuration; Figure 150: Mld Snooping Vlan Status; Table 133: Mld Snooping Vlan Status Fields - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
Field
Fast Leave Admin Mode
• If you make any changes on the page, click Submit to apply the new settings to the switch.
VLAN S
TATUS
Use the MLD Snooping VLAN Status page to view information about the VLANs on the system that are configured for MLD
snooping.
To access the MLD Snooping VLAN Status page, click LAN > Monitoring > MLD Snooping > VLAN Status in the navigation
tree.
Field
VLAN ID
Admin Mode
Fast Leave Admin Mode
Group Membership Interval
Maximum Response Time
Multicast Router Expiry Time
• Click Refresh to re-display the page with the latest information from the router.
VLAN C
ONFIGURATION
Use the MLD Snooping VLAN Configuration page to configure MLD Snooping settings for VLANs on the system.
Document 34CSFP6XXUWS-SWUM100-D7
Table 132: MLD Snooping Interface Configuration Fields (Cont.)
Description
Select the Fast Leave mode for the a particular interface from the pulldown menu. The
default is Disable.

Figure 150: MLD Snooping VLAN Status

Table 133: MLD Snooping VLAN Status Fields

Description
Displays the VLAN IDs for which the MLD Snooping mode is Enabled.
Shows the MLD Snooping Mode for the VLAN ID.
Indicates whether MLD Snooping Fast-leave is active on the VLAN.
Shows the amount of time in seconds that a switch will wait for a report from a
particular group on a particular interface, which is participating in the VLAN, before
deleting the interface from the entry. The valid range is 2 to 3600.
Shows the amount of time the switch waits after it sends a query on an interface,
participating in the VLAN, because it did not receive a report for a particular group on
that interface. The valid range is 1 to 3599. Its value should be greater than group
membership interval value.
Shows the amount of time to wait before removing an interface that is participating in
the VLAN from the list of interfaces with multicast routers attached. The interface is
removed if a query is not received. The valid range is 0 to 3600.
D-Link Unified Access System
Configuring MLD Snooping Page 229