Deleting A Remote Logging Host; Persistent Log Configuration; Figure 37: Persistent Log Configuration; Table 27: Persistent Log Configuration Fields - D-Link DWS-4026 User Manual

D-Link Unified Access System

Deleting a Remote Logging Host

To delete a remote logging host from the configured list, select the IP address of the host from the Host field, and then click
Delete.
P L C
ERSISTENT OG
The persistent log is stored in persistent storage, which means that the log messages are retained across a switch reboot.
• The first log type is the system startup log . The system startup log stores the first N messages received after system
reboot. This log always has the log full operation attribute set to stop on full and can store up to 32 messages.
• The second log type is the system operation log . The system operation log stores the last N messages received
during system operation. This log always has the log full operation attribute set to overwrite. This log can store up to
1000 messages.
Either the system startup log or the system operation log stores a message received by the log subsystem that meets the
storage criteria, but not both. In other words, on system startup, if the startup log is configured, it stores messages up to its
limit. The operation log, if configured, then begins to store the messages.
The system keeps up to three versions of the persistent logs, named <FILE>1.txt, <FILE>2.txt, and <FILE>3.txt. Upon
system startup, <FILE>3.txt is removed, <FILE>2.txt is renamed <FILE>3.txt, <FILE>1.txt is renamed <FILE>2.txt,
<FILE>1.txt is created and logging begins into <FILE>1.txt. (Replace <FILE> in the above example to specify olog for the
operation log and slog for the startup log.)
The local persistent logs can be retrieved via the Web or CLI, or via xmodem over the local serial cable.
Use the Persistent Log Configuration page to enable or disable persistent logging and to set the severity filter.
To access the Persistent Log Configuration page, click LAN > Administration > Log > Persistent Logger
Configuration in the navigation menu.
Field
Admin Status
Page 90 Managing Logs
ONFIGURATION

Figure 37: Persistent Log Configuration

Table 27: Persistent Log Configuration Fields

Description
Select whether to enable or disable persistent logging. The default is disabled.
• Enabled: Prints log messages to the device attached to the switch serial port.
• Disabled: Log messages do not print to the device attached to the switch serial port.
Software User Manual
Document 34CSFP6XXUWS-SWUM100-D7
12/10/09