Sntp Server Configuration; Figure 96: Sntp Server Configuration; Table 81: Sntp Server Configuration Fields - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
SNTP S C
ERVER ONFIGURATION
Use the SNTP Server Configuration page to view and modify information for adding and modifying Simple Network Time
Protocol SNTP servers.
To display the SNTP Server Configuration page, click LAN > Administration > SNTP > SNTP Server Configuration in the
navigation tree.
Field
Server
Address / Hostname
Address Type
Port
Priority
Version
Priority (1-3)
• To add an SNTP server, select Create from the Server list, complete the remaining fields as desired, and click Submit.
The SNTP server is added, and is now reflected in the Server list. You must perform a save to retain your changes over
a power cycle.
• To removing an SNTP server, select the IP address of the server to remove from the Server list, and then click Delete.
The entry is removed, and the device is updated.
Document 34CSFP6XXUWS-SWUM100-D7

Figure 96: SNTP Server Configuration

Table 81: SNTP Server Configuration Fields

Description
Select the IP address of a user-defined SNTP server to view or modify information
about an SNTP server, or select Create to configure a new SNTP server. You can
define up to three SNTP servers.
Enter the IP address or the hostname of the SNTP server.
Select IPv4 if you entered an IPv4 address or DNS if you entered a hostname.
Enter a port number from 1 to 65535. The default is 123.
Enter a priority from 1 to 3, with 1 being the highest priority. The router will attempt to
use the highest priority server and, if it is not available, will use the next highest server.
Enter the protocol version number.
Specifies the priority of this server entry in determining the sequence of servers to
which SNTP requests are sent. Values are 1 to 3, and the default is 1. Servers with
lowest numbers have priority.
D-Link Unified Access System
Configuring SNTP Settings Page 169