Radio; Figure 293: Ap Hardware Capabilities; Table 259: Profile - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
settings you configure in the profile are valid for all APs within the profile. Different hardware platforms might also require
different software images. As of Release 1.0, the D-Link Unified Switch supports only DWL-8600AP hardware type.
Table 259 describes the fields available on the Profile page.
Field Description
Hardware Type Select the hardware type for the APs that use this profile. The hardware type is determined, in part, by
ID the number of radios the AP supports (single or dual) and the IEEE 802.11 modes that the radio
supports (a/b/g or a/b/g/n). The option available in the Hardware Type ID is:
• DWL-8600AP Dual Radio a/b/g/n
Wired Network Enter the VLAN ID that the switch uses to send tracer packets in order to detect APs connected to the
Discovery wired network.
VLAN ID
The tracer packets help the switch identify unauthorized APs that do not belong to the D-Link Unified
Access System but are connected to the wired network.
To add a new profile, go to the WLAN > Administration > Advanced Configuration > AP Profile page, enter a name for
the new profile in the available field, and click Add.
R
ADIO
In order to accommodate a broad range of wireless clients and wireless network requirements, the DWL-8600AP supports
two radios. Radio 1 can broadcast in one of the following modes:
• IEEE 802.11a mode
• IEEE 802.11a and IEEE 802.11n modes
• 5 GHz IEEE 802.11n mode
Radio 2 can broadcast in one of the following modes:
• IEEE 802.11b and IEEE 802.11g modes
• IEEE 802.11b, IEEE 802.11g, and IEEE 802.11n modes
• 2.4 GHz IEEE 802.11n mode
You configure the default radio settings from the WLAN > Basic Setup > Radio tab, which the following figure shows.
Document 34CSFP6XXUWS-SWUM100-D7

Figure 293: AP Hardware Capabilities

Table 259: Profile

D-Link Unified Access System
Basic Setup Page 417