Viewing Named Accounting Server Status; Figure 283: Radius Accounting Server Configuration-Server Added; Table 251: Radius Accounting Server Configuration Fields - D-Link DWS-4026 User Manual

D-Link Unified Access System
If at least one RADIUS accounting server is configured on the switch, and a host address is selected in the Accounting Server
Host Address field, then additional fields are available on the Accounting Server Configuration page.
Figure 283: RADIUS Accounting Server Configuration—Server Added
Field
Accounting Server Host
Address
Port
Secret
Apply
Secret Configured
RADIUS Accounting Server
Name
Use the buttons at the bottom of the page to perform the following actions:
• If you make changes to the page, click Submit to apply the changes to the system.
• To delete a configured RADIUS accounting server, select the IP address of the server from the RADIUS Server IP
Address drop-down menu, and then click Remove.
• Click Refresh to update the page with the most current information.

Viewing Named Accounting Server Status

The RADIUS Named Accounting Server Status page shows summary information about the accounting servers
configured on the system.
Page 396 RADIUS Settings

Table 251: RADIUS Accounting Server Configuration Fields

Description
Use the drop-down menu to select the IP address of the accounting server to view or
configure. Select Add to configure additional RADIUS servers.
Identifies the authentication port the server uses to verify the RADIUS accounting
server authentication. The port is a UDP port, and the valid range is 1-65535. The
default port for RADIUS accounting is 1813.
Specifies the shared secret to use with the specified accounting server. This field is
only displayed if you are logged into the switch with READWRITE access.
The Secret will only be applied if this box is checked. If the box is not checked,
anything entered in the Secret field will have no affect and will not be retained. This
field is only displayed if you are logged into the switch with READWRITE access.
Indicates whether the shared secret for this server has been configured.
Enter the name of the RADIUS accounting server.
The name can contain up to 32 alphanumeric characters. Spaces, hyphens, and
underscores are also permitted. If you do not assign a name, the server is assigned
the default name Default-RADIUS-Server.
You can use the same name for multiple RADIUS accounting servers. RADIUS clients
can use accounting servers with the same name as backups for each other.
Software User Manual
Document 34CSFP6XXUWS-SWUM100-D7
12/10/09