Table 10: Network Connectivity Fields - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
Field
Protocol
IPv4 Fields: These display when IPv4 is selected as the protocol.
IP Address
Subnet Mask
Default Gateway
Burned-in MAC Address
Locally Administered MAC
Address
MAC Address Type
Network Configuration
Protocol Current
Management VLAN ID
Web Mode
Java Mode
Document 34CSFP6XXUWS-SWUM100-D7

Table 10: Network Connectivity Fields

Description
Selects the IP protocol version you want to configure on the interface. Depending on
your selection, different fields display. Both protocols can be configured.
The IP address of the network interface. The factory default value is 0.0.0.0
Note: Each part of the IP address must start with a number other than zero. For
example, IP addresses 001.100.192.6 and 192.001.10.3 are not valid.
The IP subnet mask for the interface. The factory default value is 0.0.0.0.
The default gateway for the IP interface. The factory default value is 0.0.0.0.
This read-only field displays the MAC address that is burned-in to the network card at
the factory. This MAC address is used for in-band connectivity if you choose not to
configure a locally administered address.
You can optionally configure a locally administered MAC address for in-band
connectivity instead of using the burned-in universally administered MAC address. In
addition to entering an address in this field, you must also set the MAC address type
to locally administered. Enter the address as twelve hexadecimal digits (6 bytes) with
a colon between each byte. Bit 1 of byte 0 must be set to a 1 and bit 0 to a 0; i.e., byte
0 must have a value between x'40' and x'7F'.
Select the MAC address to use for in-band connectivity. The factory default is to use
the burned-in MAC address.
• Burned-In: Use the factory default MAC address.
• Locally Administered: Use the MAC address you entered in the Locally
Administered MAC Address field.
Specify what the switch should do following power-up. The factory default is None. The
options are as follows:
• BootP: Transmit a Bootp request
• DHCP: Transmit a DHCP request
• None: Do not send any requests following power-up.
Specifies the management VLAN ID of the switch. The range is 1-3965. The
management VLAN is used for management of the switch. This field is configurable
for administrative users and read-only for other users.
Controls whether the switch user interface can be accessed from a Web browser. The
factory default is enabled.
• Enable: Permits Web-based management of the switch.
• Disable: Prohibits Web-based management of the switch. If the Web mode is
disabled, you must manage the switch by using SNMP or the CLI.
Controls whether to display the Java applet that displays a picture of the switch at the
top right of the screen. The factory default is enabled:
• Enable: Permits the applet to display. The Java applet lets click on the picture of the
switch to select configuration screens instead of using the navigation tree at the left
side of the screen.
• Disable: Does not allow the Java applet to display. The applet is replaced by a blank
area.
D-Link Unified Access System
IP Address Page 67