Ap Authentication Failure Status; Figure 349: Ap Authentication Failure Status - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
Field
Detection Mode
Age
AP A
UTHENTICATION
An AP might fail to associate to the switch due to errors such as invalid packet format or vendor ID, or because the AP is
not configured as a valid AP with the correct local or RADIUS authentication information.
To view a list of APs that failed to associate with the Unified Switch, click WLAN > Monitoring > Access Point > AP
Authentication Failure Status.
The AP authentication failure list shows information about APs that failed to establish communication with the Unified
Switch. The AP can fail due to one of the following reasons:
• No Database Entry—The MAC address of the AP is not in the local Valid AP database or the external RADIUS server
database, so the AP has not been validated.
• Local Authentication—The authentication password configured in the AP did not match the password configured in the
local database.
• Not Managed—The AP is in the Valid AP database, but the AP Mode in the local database is not set to Managed.
• RADIUS Authentication—The password configured in the RADIUS client for the RADIUS server was rejected by the
server.
• RADIUS Challenged—The RADIUS server is configured to use the Challenge-Response authentication mode, which is
incompatible with the AP.
• RADIUS Unreachable—The RADIUS server that the AP is configured to use is unreachable.
• Invalid RADIUS Response—The AP received a response packet from the RADIUS server that was not recognized or
invalid.
• Invalid Profile ID—The profile ID specified in the RADIUS database may not exist on the switch. This can also happen
with the local database when the configuration has been received from a peer switch.
• Profile Mismatch-Hardware Type—The AP hardware type specified in the AP Profile is not compatible with the actual
AP hardware.
• AP Image Not Available—The switch does not have an appropriate image available to deploy to the AP. This error is
valid only when the switch supports the Auto AP image upgrade and the Auto image upgrade mode is enabled.
To delete the entries for all APs from the failure list, click Delete All. To add an AP from the Access Point Failure list to the
Valid AP database, select the check box next to the MAC address of the AP and click Manage.
Document 34CSFP6XXUWS-SWUM100-D7
Table 325: Ad Hoc Client Status
Description
The mechanism of detecting this Ad Hoc device. The possible values are Beacon Frame or
Data Frame.
Time since last detection of the ad hoc network.
F S
AILURE TATUS

Figure 349: AP Authentication Failure Status

D-Link Unified Access System
Monitoring and Managing Intrusion Detection Page 503