D-Link DWS-4026 User Manual page 153

Software User Manual
12/10/09
Field
Bootp Automatic Mode
Enable
Disable
Add Excluded Addresses
From
To
Delete Excluded Addresses
• If you change any settings or add an excluded address range, click Submit to apply the changes to the system. Each
time you enter a value in the From or To fields, click Submit to add the address or address range to the excluded
address list.
• To Delete an address or address range from the excluded address list, select one or more check box beneath the
Delete Excluded Addresses field and click Submit.
Document 34CSFP6XXUWS-SWUM100-D7
Table 69: DHCP Server Global Configuration Fields (Cont.)
Description
Specifies whether to enable or disable Bootp for dynamic pools.
Allows the allocation of the addresses in the automatic address pool to the BootP
client.
Does not use the automatic address pool addresses for BootP clients. This is the
default value.
Use the From and To fields to specify the IP addresses that the server should not
assign to the client. If you want to exclude a range of addresses, set the range
boundaries.
Note: It is strongly recommended not to add thousands of addresses in the range.
The larger the range, more time will be taken by the DHCP server to assign an IP
address.
To exclude an address range, specify the low address in the range.To specify a single
address to exclude, enter the address in the From field and leave the To field at the
default value of 0.0.0.0. For example, in
192.168.17.100 to the excluded addresses list.
To exclude an address range, specify the high address in the range. To exclude a
single address, do not enter a value in this field.
After you add excluded addresses, they appear below this field title, as
shows. Each address or address range has a check box next to it.
D-Link Unified Access System
Figure 85, the user is adding the address
Managing the DHCP Server
Figure 85
Page 153