Configuring Global And Interface Ip Settings; Ip Configuration; Figure 194: Ip Configuration; Table 176: Ip Configuration Fields - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
C G
ONFIGURING
The LAN > L3 Features > IP folder contains links to the following web pages that configure IP routing data:
•

"IP Configuration"

• "IP Interface Configuration"
IP C
ONFIGURATION
Use the IP Configuration page to configure routing parameters for the switch as opposed to an interface.
To display the page, click LAN > L3 Features > IP > Configuration in the navigation tree.
Field
Default Time to Live
Routing Mode
ICMP Echo Replies
ICMP Redirects
ICMP Rate Limit Interval
Document 34CSFP6XXUWS-SWUM100-D7
I
LOBAL AND NTERFACE

Figure 194: IP Configuration

Table 176: IP Configuration Fields

Description
The default value inserted into the Time-To-Live field of the IP header of datagrams
originated by the switch, if a TTL value is not supplied by the transport layer protocol.
Select Enable or Disable from the dropdown menu. You must enable routing for the
switch before you can route through any of the interfaces. Routing is also enabled or
disabled per VLAN interface. The default value is Disable.
Select Enable or Disable from the dropdown menu. If you select Enable, then only
the router can send ECHO replies. By default, ICMP Echo Replies are sent for echo
requests.
If this is enabled globally and on the interface level, then only the router can send ICMP
redirects.
To control the ICMP error packets, you can specify the number of ICMP error packets
that are allowed per burst interval. By default, the rate limit is 100 packets per second,
i.e. the burst interval is 1000 milliseconds. To disable ICMP rate limiting, set this field
to zero. The valid rate interval range is 0 to 2147483647 milliseconds.
D-Link Unified Access System
IP S
ETTINGS

Configuring Global and Interface IP Settings

Page 283