Ip Interface Configuration; Figure 195: Ip Interface Configuration; Table 177: Ip Interface Configuration Fields - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
IP I C
NTERFACE ONFIGURATION
Use the IP Interface Configuration page to update IP interface data for this switch.
To display the page, click LAN > L3 Features > IP > Interface Configuration in the navigation tree.
Field
Slot/Port
IP Address
Subnet Mask
Routing Mode
Administrative Mode
Link Speed Data Rate
Forward Net Directed
Broadcasts
Active State
Document 34CSFP6XXUWS-SWUM100-D7

Figure 195: IP Interface Configuration

Table 177: IP Interface Configuration Fields

Description
Select the interface to configure from the dropdown menu. The dropdown menu
contains logical interfaces, including loopback interfaces and VLAN routing interfaces.
Enter the IP address for the interface.
Enter the subnet mask for the interface. This is also referred to as the subnet/network
mask, and defines the portion of the interface's IP address that is used to identify the
attached network.
Setting this Enables or Disables routing for an interface. By default, routing is disabled
on port-based routing interfaces and enabled on VLAN-based routing interfaces.
The Administrative Mode of the interface. The default value is Enable.
An integer representing the physical link data rate of the specified interface. This data
is valid only for physical interfaces and is measured in Megabits per second (Mbps).
Select how network directed broadcast packets should be handled. If you select
Enable from the dropdown menu network directed broadcasts are forwarded. If you
select Disable they are dropped. The default value is Disable.
The state of the specified interface is either Active or Inactive. An interface is
considered active if the link is up and it is in forwarding state.
D-Link Unified Access System
Configuring Global and Interface IP Settings Page 285