Viewing Associated Client Neighbor Ap Status; Figure 324: Associated Client Neighbor Ap Status; Table 299: Associated Client Qos Status; Table 300: Associated Client Neighbor Ap Status - D-Link DWS-4026 User Manual

Software User Manual
12/10/09
Field
Actual
RADIUS (Cached)
Client QoS Operational
Status
Bandwidth Limit Down
Bandwidth Limit Up
Access Control Down
Access Control Up
Diffserv Policy Down
Diffserv Policy Up

Viewing Associated Client Neighbor AP Status

The WLAN > Monitoring > Client > Associated Clients > Neighbor APs page for the associated client status shows
information about access points that the client detects. The information on this page can help you determine the managed
AP an associated client might use for roaming. Use the menu above the table to select the MAC address of the client with
the information to view.
Table 300 describes the information available on the Neighbor AP page for the associated client status.
Field
AP MAC Address
Location
Radio
Document 34CSFP6XXUWS-SWUM100-D7

Table 299: Associated Client QoS Status

Description
Use the selector to determine the source of the information the page displays:
• Select Actual to display either the actual status parameters configured on the AP.
• Select RADIUS (Cached) to display any client QoS parameters that were obtained for the
client from a RADIUS server when using 802.1X authentication.
Shows whether QoS is enforced for the client.
Shows the maximum rate at which the client receives traffic from the AP in bits per second.
The rate shown in this field is the configured value rounded down to the nearest 64 kbps, A
value of 0 means no bandwidth limiting is in effect in this direction.
Shows the maximum rate at which the client transmits traffic to the AP in bits per second.
The rate shown in this field is the configured value rounded down to the nearest 64 kbps, A
value of 0 means no bandwidth limiting is in effect in this direction.
Shows which ACL, if any, is applied to traffic from the AP to the client.
Shows which ACL, if any, is applied to traffic from the client to the AP.
Shows which DiffServ policy, if any, is applied to traffic from the AP to the client.
Shows which DiffServ policy, if any, is applied to traffic from the client to the AP.

Figure 324: Associated Client Neighbor AP Status

Table 300: Associated Client Neighbor AP Status

Description
The base Ethernet address of the Unified Switch managed AP.
The configured descriptive location for the managed AP.
The radio interface and its configured mode that detected this client as a neighbor.
D-Link Unified Access System
Monitoring Status and Statistics Page 479